Mutec MC-2 Manuel d'utilisateur télécharger pdf (Page 10)

\\\\\\\\\\\\\

CONTROL ELEMENTS

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Manual SDs-01 E 3.2.2003 18:26 Uhr Seite 6

AES 3 – 1992/2003 and AES 11 – 1997/2003. The input impedance is 110 Ω (XLR

connector, female).

4 AES/EBU ID IN

This input receives balanced digital AES/EBU blank frame reference or audio

signals in accordance with the specifications of the standards

AES 3 ID – 1995/2001. The input impedance is 75 Ω (BNC connector, female)

and can be switched off internally for chaining devices, see the »Switch-

ing-off the Termination of the AES/EBU ID Input« section in the appendix.

5 MAINS IN, Power Switch + Power Inlet

This is the main switch for switching the device on and off. Be sure to

make all connections (especially the supplied power cable) properly before

turning on the switch. Heed the SAFETY INSTRUCTIONS at the beginning of

this manual.

Connect the supplied power cable here. Make sure that the power switch

is turned off before connecting the power cable to this inlet and to the

power outlet. Line voltages within the range of 90…260 V with a frequency

of 50 or 60 Hz can be applied. The internal power supply will automatically

make all necessary adjustments.

For detailed specifications on all terminals,

refer to the PIN ASSIGNMENT OF THE

CONNECTORS and TECHNICAL DATA sections

in the appendix.

The AES/EBU ID input terminal is standardly

isolated from ground to avoid interference

from the connected clock line. If this does

not comply with the electrical studio pur-

poses, the ground connections can be linked

permanently by setting jumpers on the

mainboard. Refer to the »Connecting the

AES/EBU ID Input to Ground« section in the

appendix for a short instruction.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Mutec MC-2 Manuel d'utilisateur Page 10