Mutec MC-3+ Smart Clock Manuel d'utilisateur télécharger pdf (Page 18)

\\\\\\\\\\\\\\\\\\

ANHANG

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 16

Status Information

»STATUS« Area

This area displays different system conditions of your MC-3+. There is no

access for changing settings.

»LOCK«

This blue LED lights when the internal PLL circuit has detected the incoming

clock reference signal as valid. If the reference signal is unstable or lost, the

»LOCK« LED does not light.

»HOLD«

This red LED lights when the external reference clock signal is interrupted

or lost. The frequency synthesizer of the MC-3+ keeps generating all output

signals continuously, based on the last incoming clock rate. Thus, your

studio set-up receives non-interrupted clock supply, regardless if a valid

external referecne signal is present, unstable or lost. Re-synchronization is

carried out without affecting any of the outputs signals critically.

»AUDIO«

This red LED lights when a valid AES3/11 or S/P-DIF optical or coaxial digital

audio reference signal is detected at the corresponding input.

»CLOCK

IN« Area

This area displays the clock rate of the incoming clock or digital audio

reference signal. The following basis reference clock rates are supported

and will be analyzed:

32.0kHz 44.1kHz 48.0kHz 88.2kHz 96.0kHz

176.4kHz 192.0kHz

Supported Input Clock Rates

12,288.0MHz11,289.6MHz10.0MHz

Generic Functions

There are two additional functions which influence the working of your

whole MC-3+ Smart Clock:

Front Panel lock out + LED shut down

When pressing both front panel keys together at one time, all LEDs will

shut down except the »POWER« and »LOCK« LEDs. Additionally, the

functions of both keys are also blocked to prevent unauthorized operation,

which is important during e.g. live events.

To reactivate the keys and the LEDs, please press both keys for apperox.

four seconds until all LEDs light again.

Factory Reset

You can reset the operating system of your MC-3+ Smart Clock to the

initial status by switching on the unit while pressing the »MENU« key

simultaneously.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Mutec MC-3+ Smart Clock Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Mutec MC-3+ Smart Clock